Neonate BC-8000DV Kurzanleitung Seite 14

ENGLISH
How to avoid (turn off) OUT-OF-RANGE
alarm when changing from using one or
more baby units with a single parent unit
Prerequisites:
Parent unit must be turned on.
Touch sensitive buttons must be activated
(are activated / deactivated by ON / OFF
button)
When the parent unit is connected (paired) with
more than one baby unit, the parent unit will
constantly search for signals from all connected
baby units. That means if you pair two baby
units to your parent unit but decide to use
just one of one them (by turning only one BU
on), the parent unit will activate the OUT-OF-
RANGE alarm indicating that it has lost contact
with one baby unit.
Parent unit: Press and hold the (•) button for
1
2 seconds to enter the menu
Parent unit: Use the (-/+) buttons to select
2
BABY SETTINGS in menu. Confirm
choice by pressing (•) button. Now choose
RANGE ALARM and confirm choice by
pressing (•) button. Now use the (-/+) but-
tons to choose whether range alarm should
be ON or OFF. Confirm choice by pressing
(•) button.
14
If you would like to change range alarm settings
on a different baby unit, then you need to change
the number to the right of BABY (showing
BABY 1 in below picture).
NOTE! To avoid the possibility that parents
forget to activate the out-of-range alarm again
after it has been disabled, the out-of-range alarm
is automatically activated after the unit is turned
off and on again. We do not recommend turning
off the out-of-range alarm when the parents will
not be notified if parent unit loses contact with
baby unit. There are several reasons to parent
unit loses contact with baby unit; 1) units are
outside communication range, 2) baby unit is
turned off intentionally or 3) baby unit is turned
off without purpose (e.g. by empty battery).