x-sense SD06 Bedienungsanleitung Seite 6

BEDROOM HALL
GARAGE KITCHEN
BASEMENT
fil
How to Install This Alarm
I IMPORTANT!
THIS SMOKE ALARM IS DESIGNED TO BE MOUNTED
I WARNING!
FAILURE TO PROPERLY INSTALL AND ACTIVATE
WILL PREVENT ITS RESPONSE TO FIRE HAZARDS.
Mounting Steps
l. Drill three Ø 6.0 mm holes in the wal or ceiling, then insert three plastic anchor plugs into the holes with a hammer.
2. Attach the mounting bracket to the surface of the wal or ceiling with three screws and mount the alarm into the
bracket by pushing them together and tw•sting the unit clockwise.
3. Test the unit by using the Test/Si ence button. Ensure the unit sounds in an a arm pattern.
Note: This model is equipped with a feature that automatically
the mounting bracket for the first time.
MASTER BEDROOM
FIRE EXTINGUISHERS
O
SMOKE ALARMS
FAMILY ROOM
CARBON MONOXIDE
ALARMS
SMOKE & CO ALARMS
WORKSHOP
ON THE CEILING OR WALL.
THIS ALARM WILL PREVENT PROPER OPERATION
activates the alarm when the alarm is attached to
• 08 •
Deactivation
! WARNING!
I DO NOT DEACTIVATE
2 ONCE THE MAXIMUM LIFETIME (10 YEARS) IS REACHED, THE ALARM DELIVERS 2 BEEPS EVERY30 SECONDS
3 ONCE THE ALARM
REPLACED
To Deactivate
Pressing the Test/Si ence button can si ence the end of- ife signal for up to 3 days.
1. Peel back the shaded abel obstructing the "DIS" setting, and break the thin plastic guard, as below.
OF THE ALARM AND
2.Twist the plastic Pin upwards to the "DIS' position or insert a screwdriver into the slot and turn the dial clockwise to
the "DIS position.
3. Dispose of the alarm.
4. Replace the alarm.
of the Alarm
THE ALARM UNIT UNTIL THE END-OF-LIFE
IS DEACTIVATED, IT WILL NO LONGER FUNCTION
the Alarm
• 09 •
SIGNAL HAS BEEN HEARD
IT CANNOT BE REACTIVATED AND MUST BE