HPI Racing SAVAGE FLUX 2350 brushless system Bauanleitung Seite 11

5
ESC Setup
You must setup the ESC before running the first time. Afterthe initial setug it is not required before every run.
Please readthrough instructions and get familiar with
moves quickly, and it will help you to be ready for each SEP.
se
onglvcommend removing so-
Start with transmitter ON and the ESC switched OFF. A djustthe ürotde trim to the center position.
Installation is reverse of removal.
En
Wke sure üe tansmiter
Hold Full throttle while
switching on esc
Etz
ON
Confirmation
ff the LED on the speed confrol does not WON as shown below, the speed control may not be setup proMy.
Fun Throttle I FD (Greg)) Li"ng
LED (B)
procedure before starting setup. The semp
your fres before calibration as asafety precaution!
Wx6mm
87546
Glow Plug Wrench
You will hear a shott series Move trigger to full brake
of tones followed by a two position
second pause, followed by hear a long series of tones.
a long series of tones.
Release trigger
and hold until you to return to neutral position.
YELLOW mLOW
( "E000"
Repeat
Li%g
11
Deutsch
P.13Franeais
4
Thmttle
allowing it You will hear a long series
of tones followed by a two
second pause, followed by
a short series of tones.
YELLOW
eaoo•
• " eoao"
mm-7-Ebt—gago.
7b*T.
setup process.
1 LigÆg
Fug Brake
FLUX
Trim