PIZZA GROUP PYRALIS Gebrauchs- Und Wartungsanleitung Seite 56

- Then press the button
number from 0 to 7 (0 = delay switch disabled, 1=Monday, 7=Sunday) ;
- Use the button
- In the same way also set the hours, indicated by " hh" and the minutes using "nn".
After confirming the minutes with
hours again and "nn" minutes until the "two" flashing points" appear
start is enabled.
5) ALLARMS:
ALARM CAUSE
Er1 Top probe defective
Er2 Bottom probe defective
Err Card probe/cold joint defective
Card probe/cold joint temperature
Hit
higher than parameter P10
for 3 seconds to enter the setting where flashing "dd" initially appears and then a
or set the day of the week and confirm with
the card returns to the parameter of the Day "dd", confirm the "hh"
: "and the clock icon turns on indicating delay
EFFECT
Deactivation of Top
heating elements and
intermittent buzzer
Deactivation of Bottom
heating elements and
intermittent buzzer
Deactivation of Top and
Bottom heating elements
and intermittent buzzer
Deactivation of Top and
Bottom heating elements
and intermittent buzzer
RESETTING
Check the connections
and operation of the top
probe
Check the connections
and operation of the Top
probe
Non-recoverable: replace
tab
Wait for the temperature
to go below parameter
P10 and check
overheating causes.
56