Quick Tools QU862DW+ Bedienungsanleitung Seite 24

1) Install the heater on the ⑥ Handle
components, and the square column on the
heating body is facing the square hole on the
wiring seat.
2) Cover ① Steel tube to ③ Heater;
3) Install the ⑥ Handle components
into the ⑦ Handle body, pay attention
to the alignment of the four holes;
4) Turn Four screws②;
5) After replacing the heater, you are advised to perform the following
measurements
6) Calibrate the temperature, refer to
1. Remove the two screws securing the handle holder on the right side of
the machine as shown. Align the mounting hole of the handle holder
with the two screw holes on the machine and tighten the two screws
removed.
2. Install the handle holder, place the air handle, and check whether it is
suitable.
NOTE: The handle holder can be installed on the left or right side of the
machine according to actual needs.
We hope you enjoy using your QUICK HOT AIR STATION and are interested in
your suggestions for improvements.
Please also contact us if you have any problems or questions regarding your
application.
Your team from Bräunlich GmbH
Soldering temperature
10
USER MANUAL
te the termi
•
calibration.
The square