Storch ColorFree Originalbetriebsanleitung Seite 40

Connecting to the ColorFree top control
Unplug the power plug. The connecting cables are already fitted with plugs and must be
connected to the cables of the ColorFree top separating unit after the pump installation.
Then connect the cables of the same colour of the pump and separating unit with the
connectors on the rear of the separating unit. Make sure that the plugs are firmly seated
and that they are engaged.
NOTE:
Depending on the production period, it may happen that the above-mentioned plug con-
nection is not installed, but that appropriate connecting terminals are fitted on the side of
the device. To connect the wastewater pump, the existing plugs on the pump must then
be cut off and the cable ends stripped by approx. 0.5 - 1 cm. Then the small clips on the
clamps must be lifted and the cables of the pump must be pushed into the lower cable
opening. Then push the clamp back to its original position.
ATTENTION:
Make sure that the colours of the cables coming from the pump match
the colours of the cables coming from the system! Then position the cables and/or the
connecting terminals on the distribution box or cable duct at the rear of the ColorFree top
system.
Connection in the cable duct Connection in the distribution box
Translation of the original instruction
40