Overview Of The Product - Hilti PR 2-HS A12 Bedienungsanleitung

▶ If the battery gets noticeably hot when not in use, this may indicate that the battery or the tool / battery
system is faulty. In this case, place the tool in a non-flammable location, well away from flammable
materials, where it can be kept under observation and allowed to cool down.
3 Description

3.1 Overview of the product

3.1.1 PR 2-HS A12 rotating laser
Laser beam (plane of rotation)
@
Rotary head
;
Grip
=
Battery release button
%
3.1.2 PR 2-HS A12 control panel
On/off button
@
LED: Auto-leveling
;
Button and LED: Shock warning deactiva-
=
tion
3.1.3 PRA 20 laser receiver control panel
On/off button
@
Volume button
;
Units key
=
3.1.4 PRA 20 laser receiver display
Indicator showing distance from laser plane
@
Volume indicator
;
Rotating laser low battery indicator
=
Battery status
%
3.1.5 Intended use
The product described is a rotating laser with a visible rotating laser beam. It can be operated by one person.
The tool is designed to be used for determining, transferring and checking references in the horizontal and
inclined planes. Examples of uses are transferring datums and heights.
▶ Use only the Hilti B 12⁄2.6 Li-Ion battery for this product.
▶ Use only the Hilti C 4⁄12­50 charger for this product.
3.1.6 Features
The rotating laser can be used horizontally and for inclined planes.
The tool is equipped with the following operating status indicators: auto-leveling LED, inclination angle LED
and shock warning LED.
Auto-leveling
Auto-leveling is carried out by two built-in servo motors after switching on. LEDs indicate the current
operating status. Auto-leveling is active within the ±5° range relative to the horizontal plane and can be
deactivated by pressing the
with the aid of suitable mounting brackets.
Inclination angle
Alternatively, in inclined plane mode, the slope adapter can be adjusted manually to achieve slopes of up to
60%. Auto-leveling is not active.
Automatic cut-out
The tool switches off automatically if it is unable to level itself, because the laser:
• is inclined at more than 5° relative to the horizontal plane.
• is blocked mechanically.
16
1
2
3
4
button. The tool can be set up directly on the ground or floor, on a tripod, or
Li­ion battery
&
Battery charge status display
(
Control panel
)
Base plate with 5/8" thread
+
Button and LED: Manual inclined plane
%
mode
Battery charge state LEDs
&
Receiving area
%
Marking notch
&
Display
(
Indicator showing position of receiver
&
relative to height of laser plane
Display
(
Marking notch
)
Receiving area
+