Before Use; Operation; Examples Of Applications - Hilti PMP 42 Bedienungsanleitung

5.4 Laser classification for laser class 2 / class II
appliances
Depending on the version purchased, the tool complies
with Laser Class 2 in accordance with IEC825-1:2007 /
EN60825-1:2007 and Class II in accordance with CFR
21 § 1040 (FDA). This tool may be used without need
for further protective measures. The eyelid closure reflex
protects the eyes when a person looks into the beam
unintentionally for a brief moment. This eyelid closure
reflex, however, may be negatively affected by medicines,
alcohol or drugs. Nevertheless, as with the sun, one
should not look directly into sources of bright light. Do
not direct the laser beam toward persons.
5.5 Electrical
a) Insulate or remove the batteries before shipping the
tool.
b) To avoid pollution of the environment, the tool
must be disposed of in accordance with the cur-

6 Before use

6.1 Inserting the batteries 2
DANGER
Use only new batteries.

7 Operation

7.1 Operation
7.1.1 Switching the laser beams on
Press the on/off button once.
7.1.2 Switching the tool / laser beams off
Press the on/off button until the laser beam is no longer
visible and the LED goes out.
NOTE
The tool switches itself off automatically after approx. 15
min.
rently applicable national regulations. Consult the
manufacturer if you are unsure of how to proceed.
c) Keep the batteries out of reach of children.
d) Do not allow the batteries to overheat and do not
expose them to fire. The batteries may explode or
release toxic substances.
e) Do not charge the batteries.
f) Do not solder the batteries into the tool.
g) Do not discharge the batteries by short-circuiting.
This may cause them to overheat and present a risk
of personal injury (burns).
h) Do not attempt to open the batteries and do not
subject them to excessive mechanical stress.
i) Do not use damaged batteries.
j) Do not mix old and new batteries. Do not mix
batteries of different makes or types.
5.6 Liquids
Incorrect use may cause liquid to leak from the batteries.
Avoid contact. If contact accidentally occurs, flush
with water. In the event of the liquid coming into
contact with the eyes, rinse the eyes with plenty of
water and consult a doctor. Liquid leaking from the
battery may cause irritation or burns.
1. Remove the foot from the tool.
2. Open the battery compartment.
3. Remove the batteries from the packaging and insert
them in the tool.
NOTE Only batteries recommended by Hilti may be
used to power the tool.
4. Check that the battery terminals are positioned cor-
rectly as shown on the underside of the unit.
5. Close the battery compartment. Check that the
catch engages properly.
6. Refit the foot to the tool.
7.1.3 Deactivating the automatic power-off feature
Press and hold the on/off button for approx. 4 sec. until
the laser beam blinks three times as confirmation.
NOTE
The tool will be switched off when the on/off button is
pressed or when the batteries are exhausted.

7.2 Examples of applications

7.2.1 Setting out drywall track for a partition
wall 3
en
13