Bresser 4Cast PRO WIFI Weather Center Bedienungsanleitung Seite 50

Step 3
Insert the other side of the pole to the square hole of
the plastic stand .
Note:
Ensure the pole and stand's indicator align .
Step 4
Place the nut in the hexagon hole of the stand, then
insert the screw in other side and then tighten it by the
screw driver .
Install the wireless 7-in-1 sensor in
an open location with no obstructions
above and around the sensor for
accurate rain and wind measurement .
Install the sensor with the smaller end
facing the North to properly orient the
wind direction vane .
Secure the mounting stand and clamps
(included) to a post or pole, and allow
minimum 1.5m off the ground.
Add rubber
pads before
mount on the
pole
6
Point to
NORTH
1.5 meter off
the ground