Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Switch the product on. Move the comb in the op-
posite direction to the hair growth, and from the
outer tip of the eyebrow towards the nose.
To trim hair just above the skin surface, remove
the comb attachment
and guide the blade
9
1
directly over the skin in the desired area.
Note: To trim only individual hairs, adjust the
angle of the blade
and guide this against
1
the individual hairs.
Cleaning, care and storage
Note: Always switch off the product before cleaning it.
Do not use any corrosive or abrasive cleaning
agents. This might damage the surface of the
product.
Clean the housing with a dry cloth.
Take off the comb attachment
(see Fig. C)
9
and clean the blade
carefully under the run-
1
ning water (see Fig. D). Then fully dry the blade
before using the product again.
1
Attention: The product is only protected against
from splash water. Never immerse it in the water.
Otherwise, irreparable damage may results.
If there are still hair on the blade
, clean it with
1
the double-sided cleaning brush
(see Fig. D).
12
16 GB
Werbung
