Setting The Oven Clock; Programming; Sampie Programme; Alarm - Bosch Hsg 188 R Eu Gebrauchsanleitung

Setting the oven clock

Setting the clock
Fig. 11
u Press button 1
a Set the clock by pressing the (+) or (—)
button.
The clock will start 7 seconds after
pressing the end (+/—) button,

Programming

The oven clock can be used to allow the
program to run in semiautomatic mode.
This means: You start the cooking
process yourself, but it will stop
automatically at a specified time (end
time).
Setting the oven clock
O The programme can also be set using
the (+) and (—)buttons,
a A maximum of 99 minutes
u If you press the (+) button during the
programme, the time will increase in
stages of 10 seconds.
C) Pressing the (—)button results in the
value being decreased in stages of 10.
NOTE: The oven clock serves only as
a warning tone.
Sample programme
If your meal is to be ready in 30 minutes,
press the (+) button of the clock until
00:30 appears' i n the display.Shouldyou
go past this value by mistake, you can
press the (—)button in order to correct the
value. The oven will start up once all
buttons and controls
The clock will count
When 00:00 appears in the display, all
functions of the oven will be switched
18
can be set.
have been released.
down in seconds.
off.
Cancelling the programme
In order to cancel the programme, you
must press the (+) and (—)buttons at the
same time. You will have to release the
(+) button first.

Alarm

Signal frequency selection
At the end of the programme, a warning
tone will sound for 7 seconds. You may
switch off the warning tone prematurely
by pressing the (+) button.
Whilst the current time is displayed in
the clock display, a signal frequency
can be selected by pressing button (-).
O The oven features three different signal
frequencies.
Cleaning, Care and
Maintenance
Please observe the fotlowing information
about cleaning, care and maintenance:
1.
Forsafety reasons, all operations
must be preceded by the
disconnection of the gas supply by
means of the flow regulator.
2.
Remove the mains plug from the
socket.
3.
If the appliance is still warm, wait until
it has cooled.