Checking The Battery Charge Level; Recharging The Battery; Inserting / Removing The Device's Battery Pack; Choice Of Gear - Parkside Pabs 20-Li E6 Originalbetriebsanleitung

GB MT
Checking the battery
charge level
The battery's (8) charge level is indicated
by the charge state indicator (7).
The­LEDs­indicate­the­battery's­charge­
level, when the device is in operation.
To do this, press the softkey (6) of the
charge level indicator (7).
red-yellow-green => Battery fully charged
red and yellow
=> Battery half charged
red => Battery needs

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (8) when the
red­LED­on­the­charge­status­indicator­
(7) is on.
1. Remove the battery (8) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (8) in the charging
compartment of the battery charger (17).
3. Plug the battery charger (17) into a
mains outlet.
4. Once charging is complete, disconnect
the charger (17) from the mains supply.
5. Remove the battery (8) from the char-
ger (17).
Overview of the control display on
the charger (17):
Green LED lights up without battery
inserted: Charger ready.
Green LED lights up:
Battery such alleged charged.
24
to be charged
Red LED lights up: Battery charging.
Red LED flashes: Battery overheated
Red + green LEDs flash:
Defective battery
Inserting / removing the
device's battery pack
Inserting the battery pack:
1. Move the rotation direction switch (11)
onto its middle setting (lock).
2.Slide the foot of the device onto the bat-
tery pack (8) until it clicks into place.
Removing the battery pack:
1. Push the release button (9) and pull the
battery pack (8) out towards the front
of the device.

Choice of gear

Slide the gear selector (4) to 1 or 2,
corresponding to a low or high torque
selection.
1st gear ............................ 0-400 min
2nd gear ......................... 0-1400 min
A gear change may only be
performed in standstill mode!
Set the direction of
rotation
you­can­select­the­direction­of­rotation­
with the direction switch (clockwise and
anticlockwise direction) and secure the
device against accidental start up.
The arrow on the direction switch indicates
the working direction.
1. Wait for the device to shut-down.
2. Push the direction switch (11) into the
desired position:
-1
-1