Silvercrest SHSA 20-Li A1 Originalbetriebsanleitung Seite 34

GB MT
too low, the motor speed is adjusted. This
operating time is approx. 20 Min.
Using ECO mode (Fig. A)
1. Press the on/off switch (9) once to
switch the appliance on.
2. The appliance runs in ECO mode.
Using Turbo mode (Fig. A)
1. Press the on/off switch (9) a second
time.
2. The appliance will now run in turbo
mode.
Changing mode (Fig. A)
1. Press the on/off switch (9) a third time.
The appliance switches off.
2. For the desired mode, repeat the pro-
cess of using ECO mode / Turbo
mode.
Cleaning, maintenance
and storage
WARNING! Risk of injury due to un-
intentional start-up. Protect yourself when
performing maintenance or cleaning work.
Switch off the device and remove the bat-
tery (18).
You should have any repair and mainten-
ance work that is not described in these
instructions carried out by our Service
Centre. Only use original replacement
parts.
Cleaning
General cleaning
WARNING! Electric shock! Never
spray down the device with water.
Notes
• Risk of damage. Chemical substances
may attack the plastic parts of the ma-
chine. Do not use any cleaning agents
or solvents.
34
• Make sure to keep the ventilation open-
ings free of foreign objects.
• Clean the surface of the appliance with
a soft brush or cloth.
• Empty the collection container (1) after
every use.
• Clean the collection container (1) with
a damp cloth.
Cleaning the filter
(Fig. A)
1. Remove the collection container (1),
see Attaching and removing the
collection container, p. 31.
2. Remove the filter holder (4) / filter (5),
see Attaching and removing the filter
holder/filter, p. 32.
3. Tap the filter (5) and clean it with a
brush or compressed air.
4. You can also clean a heavily soiled fil-
ter (5) under running water. The filter
(5) must be completely dry before re-
use.
5. If the filter (5) is too dirty, replace it
with a new filter (5) (see Spare parts
and accessories, p. 39).
6. Fit the filter holder (4) / filter (5), see
Attaching and removing the filter
holder/filter, p. 32.
7. Attach the collection container (1), see
Attaching and removing the collection
container, p. 31.
Cleaning the motorised brush
attachment
Note
Remove the motorised brush attachment
(15) from the appliance before cleaning.
Only fit a dry attachment back onto the
appliance.
(Fig. B)
1. Open the protective grille (23).
2. Slide the brush release (22) forwards.