Displaymodus; Preset - Storing Presets Manually - T+A Elektroakustik T 1210 R Betriebsanleitung

Displaymodes
To switch the display mode between RDS mode and a
display of transmitter field strength, press the remote
control buttons in the sequence described above.
If you change stations when the normal mode (RDS) is in
use, first the reception frequency appears in the display,
then the tuning indicator.
If a station is tuned in correctly, the RDS station name
appears on the screen after a few seconds - provided
that the station concerned
information.
It is also possible to switch to a display of field strength if
you wish to assess reception conditions, or position a
rotary aerial accurately.
Preset – storing presets manually
The tuner can store a total of 60 station settings
(presets). The preset stores the frequency and the
reception mode, and also the RDS station name - pro-
vided that it was picked up in full at the time it was stored.
When you call up a preset the tuner reverts to the exact
setting in which the preset was stored.
Before you store a preset the station must first be tuned
in accurately; you may have to wait until the complete
RDS station name appears on the screen. Then you
should press the remote control buttons in the sequence
shown above.
The screen shows a ' P P P P ' on the left followed by a flashing
number, with the station frequency after that, e. g.:
' P28 104,90 P28 104,90 P28 104,90 P28 104,90
The flashing number is the preset number under which
the current station will be stored. You can change the
preset number using the 
enter the number you want to use directly using the
numeric buttons.
is broadcasting
' MHz.
 and   buttons, or you can
   
When the field strength display is switched on, the screen
is always set to normal brightness, regardless of the
previous setting. Next you will see an 'L' (Level) on the
left of the screen (instead of the preset number or centre
display), followed by a numerical value. The display
range is 0 ... 25.
Note:
RDS
In use of the  system handset F1 you can use this
function by pressing the 
To store the setting under the current pre-set number you
must press the 
the message '
frequency. The pre-set is now stored, and the MANUAL
STORE process is ended.
If none of the menu control buttons (
 ) are pressed for a period of about ten seconds, 
 
the unit interrupts the special functions menu and reverts
to the standard display. (time-out).
Note:
If you attempt to store an invalid preset number (xx), the
machine responds with an error message on the screen:
' Pxx ERROR Pxx Pxx Pxx ERROR ERROR ERROR '; the tuner then terminates the special
functions menu.
The RDS norms state that the station name must be
broadcast in static form, but many stations present the
information as a moving script. If this occurs, do not store
the preset until the transmitter broadcasts its station
name constantly for a fairly stable period.
38
 buttom.
 
 button. The screen then shows
 
STORE STORE STORE STORE ' for a brief period instead of the
 ,     /     or  