Front Panel Controls - T+A Elektroakustik T 1210 R Betriebsanleitung

T 1210 R ON
   
   
Switches the unit on and off. When the unit is switched
on and ready to use, the green LED above the switch
glows.
If the T 1210 R is connected to a 'R' series re-amplifier or
integrated amplifier then it can be switched to the
Standby state by pressing the 
remote control unit.
When in Standby mode the unit is not completely
switched off.
 
 
Caution!
The mains button does not disconnect the unit
from the mains supply. Even when the green
LED is off, parts of the unit remain connected to
the mains supply. If the unit is not to be used
for a long period we recommend that you
disconnect the mains plug at the wall socket.
   
 
 
This button toggles the tuner between STEREO and
MONO reception. The mode just selected appears briefly
in the display every time you press the 
' MONO MONO MONO MONO ' or '
 ' glows in the display window when you
A symbol '  
have selected STEREO mode.
When a station is very weak or very distant, and can only
be received with serious background hiss, then you
should switch to MONO reception. This reduces back-
ground noise substantially.

Front panel controls

 switch on the
 
 button:  
STEREO STEREO STEREO STEREO '.
MO/ST WID/NAR
   
   
This button toggles
(NARROW) and wide bandwith (WIDE) of the IF stage.
The mode just selected appears briefly in the display
every time you press the 
' NARROW NARROW NARROW NARROW
A symbol '    ' glows in the display window when you have
selected WIDE mode.
The T 1210 R's basic reception mode is NARROW. At
this setting the tuner suppresses interference from
adjacent transmitters,
reproduction quality even under difficult reception
conditions.
However, if reception conditions are very good, and if
there are no transmitters adjacent to the station selected,
then you can achieve even better results by switching to
the WIDE setting. The theoretical drawback of this mode
is reduced selectivity, so if you hear interference on the
WIDE setting, we suggest that you switch back to
NARROW.
   
 
 
On / Off switch for the input attenuator. Every time you
press the   button the display briefly shows the  
actual setting:
' ATTEN ON ON ON ON ATTEN
ATTEN ATTEN
A symbol '' glows in the display window when the
input attenuator is switched on.
If you are listening to a station close to an unusually
powerful local transmitter, you may hear intermodulation
effects (whistling and twittering sounds). If this happens,
switch on the input attenuator.
30
between narrow bandwith
 button:  
' or ' WIDE WIDE WIDE WIDE '.
and produces outstanding
' or ' ATTEN ATTEN OFF OFF '.
ATTEN ATTEN OFF OFF