Es-Lt6N Es-Lt4N Es-Lt2N; Cleaning The Shaver - Panasonic ES-LT2N Bedienungsanleitung

• The shaver can be used for approximately 2 weeks with a full
charge.
(Based on one 3‑minute dry‑shave use per day until the
battery is exhausted)
• The number of usable days varies depending on the
following conditions.
- Beard thickness
- Pressure applied to the skin
- Ambient temperature
- Usage frequency of the sonic vibration cleaning mode

Cleaning the shaver

Do not use kitchen, bathroom, or toilet detergents. Also, do not
wipe with thinners, benzine, alcohol etc.
Doing so may result in malfunction.
1. Turn the power switch OFF, and disconnect the AC adaptor.
• Unlock the switch lock.
2. Apply some hand soap and some water to the system outer foil.
3. Press the power switch for
more than 2 seconds to
activate the sonic vibration
cleaning mode.
• The battery capacity
lamps blink in order.
ES-LT6N/ES-LT4N
• The battery capacity lamp (
( ) blink alternately.
• After about 20 seconds, it will be automatically turned off.
4. Remove the outer foil section [A9]
and press the power switch for more
than 2 seconds to activate the sonic
vibration cleaning mode.
ES-LT6N_4N_2N_EU.indb 17
ES-LT6N/ES-LT4N ES-LT2N
) and the charge status lamp
ES-LT2N
5. Clean the shaver, the outer foil section,
and the trimmer with running water.
• After rinsing with water, shake the
shaver up and down for a few times
to remove excess moisture.
Hitting the vanity, etc., while shaking
the shaver may cause malfunction.
• Splashing is reduced by rinsing the shaver in sonic
vibration cleaning mode.
6. Wipe off any drops of water with a dry cloth.
7. Dry the outer foil section, the shaver,
and the trimmer completely.
8. Attach the outer foil section to the shaver.
9. Lubricate the shaver.
Lubrication
To maintain shaving comfort for a long time, it is
recommended that the oil provided with the shaver is used.
1. Switch off the shaver.
2. Apply one drop of oil to each of
the system outer foil.
3. Raise the trimmer and apply a
drop of oil.
4. Switch the shaver on, and run it
for approximately five seconds.
5. Switch off the shaver, and wipe off any excess oil from the
system outer foil with a soft cloth.
17
2015/04/17 12:47:14