Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Completely remove the transport-protection (adhesive tape) of the accessories.
Be very careful and do not use any aggressive or abrasive detergents to remove
residuals of the transport-protection.
3. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
4. If the appliance is positioned beside another fridge or freezer, leave at least a
free space of 2.0 cm between the appliances in order to avoid condensation.
5. Check that the appliance and the power cord are not damaged.
6. Install the appliance in a dry and well-ventilated place.
7. Protect the appliance from direct sunlight.
8. The doors must open completely and without hindrance.
9. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
10. Connect the appliance to the mains properly.
11. The nameplate is situated inside the appliance or at the back.
3.2 Ventilation
Observe the required minimum distances for proper ventilation.
NOTICE! Fix the plastic wall spacers (depending on model) on the
condenser at the back of the appliance to ensure a ventilation gap
between the appliance and the wall.
M
INIMUM DISTANCES REQUIRED FOR PROPER VENTILATION
Back ↔ wall
Sides ↔ wall
Free space above
The following minimum distances are recommended by the manufacturer to ensure
Back ↔ wall
Right / left ↔ any piece of furniture / wall
Free space above
These minimum distances may be less, but to do so can increase the power
consumption of the appliance.
optimum efficiency of the appliance:
51
:
min. 20 mm
min. 20 mm
min. 100 mm
min. 50 mm
min. 100 mm
min. 300 mm
Werbung
