Storage, Transportation; Troubleshooting - Lux Tools B-Rm-145/46 Originalbetriebsanleitung

GB
– Check the electrode for discoloration.
Standard colour: Light brown
– Check electrode spacing. Correct spac-
ing: 0.7–0.8 mm
Cleaning the spark plug
NOTICE! Risk of damage to the
device! Only use wire brushes with
brass bristles to clean the spark
plug. Any other bristle type will
damage the electrode!
– Remove rust deposits from the electrode
with a wire brush.
Replacing the spark plug
NOTICE! Risk of damage to the
device! Only screw a spark plug
into place when the engine is cold.
– Insert the cleaned or new spark plug and
tighten by hand.
– Tighten the hand-tightened spark plug
using a spark plug wrench by a further
quarter of a turn. Do not turn it further as
this will damage the thread.
– Affix the spark plug connector (14) firmly
back onto the spark plug.
Error/Fault
Motor does not start.
Motor runs but with interruptions Is the air filter dirty?
The motor does not reach the
maximum speed.
Strange noise.
46

Storage, transportation

Storage
– Clean unit before storing.
– Store the tool in a dry and well ventilated place.
Transportation
– When dispatching, try to use the original

Troubleshooting

What to do when something doesn't work...
Malfunctions are often caused by minor faults.
You can easily remedy most of these yourself.
Please consult the following table before con-
tacting the vendor. You will save yourself a lot
of trouble and possibly money too.
Cause
Tank empty?
Ignition cable connector loose? Push the connector firmly onto
Ignition cable connector con-
taminated?
Spark plug contaminated?
Spark plug defective?
Distance from electrode to
spark plug too great?
Incorrect fuel?
Spark plug contaminated?
Distance from electrode to
spark plug too great?
Incorrect fuel?
Screws/parts come loose?
DANGER! Risk of injury! Store
the unit in such a way that it cannot
be started by unauthorised persons.
Ensure that no one is able to hurt
themselves on the stored unit.
NOTICE! Risk of damage to the
device! Do not stored unprotected
in a damp environment.
packaging, if possible.
DANGER! Risk of injury! Unpro-
fessional repairs may mean that your
unit will no longer operate safely. This
endangers you and your environment.
Remedy
► Filling with fuel – p. 43
the spark plug.
Clean connector.
► Cleaning/replacing spark
plugs – p. 45
Set gap at 0.7–0.8 mm.
Drain tank and fill up with the
correct fuel.
► Cleaning the air filter – p. 45
► Cleaning/replacing spark
plugs – p. 45
Set gap at 0.7–0.8 mm.
Empty tank and fill up with the
correct fuel.
Tighten screws.