HBM ME50S6 Bedienungsanleitung Seite 5

ME50S6
Maintenance and cleaning
The Clip Electronic are maintenance-free. Please note the following points
when cleaning the front panel:
• Remove the mains plug from the socket before cleaning.
• Clean the front panel with a soft, slightly damp (not wet!) cloth. Never use
solvents, since they may damage the labelling on the front panel.
• When cleaning, please ensure that no liquid finds its way into the device or
onto the contacts.
Residual dangers
The ME50S6 scope of performance and supply covers part of the measuring-
technology, only. The plant designer/constructor/operator must in addition de-
sign, realise and take responsibility for the measuring-system's safety such
that potential residual dangers are minimized. The respective regulations
must in any case be observed. Residual dangers regarding the measuring
system must be specified explicitly.
Markings used in this document:
The marking below warns of a potentially dangerous situation in which failure
to comply with safety requirements can result in death or serious physical in-
jury.
Safety instructions have the following format:
Signal word
Consequences of non−compliance
Preventive measures
− Warning sign:
− Signal word:
− Type of hazard:
− Consequences:
− Prevention:
A0260−3.0 en/de/fr
Alerts of a hazard
Designates the degree or level of the hazard
(see table below)
Designates the type of source of hazard
Describes the consequences of non−compliance
Indicates how to avoid the hazard
5
HBM