Daily Use - IKEA DAGLIG Bedienungsanleitung

ENGLISH
Heat setting dis-
play

Daily use

Switching on and off
Touch for 2 seconds to switch the appli-
ance on or off.
Adjusting the heat setting
Touch the control bar where there is a de-
sired heat setting. Correct to the left or the
right, if necessary. Do not release before
you reach a desired heat setting.
Switching the oval zone on and off
Switch the oval zone by touching
seconds. Repeat the procedure to switch off
the outside ring.
Before an outside oval can be switched
on, the inside ring must be switched on.
Switching the outside rings on and off
Switch on the inside ring before you switch
on the outside rings by touching
seconds. For more outer rings touch the
same sensor field again. The subsequent in-
dicator comes on. Repeat the procedure to
switch off the outside rings.
Using the Timer
Touch repeatedly until the pilot light of a
desired cooking zone displays. For exam-
ple, for the front left zone.
Description
A cooking zone is still
hot
The Child Safety De-
vice or the Lock is on
The Automatic Switch
off is on
The Stop+Go is on
1-2
for 1-2
Residual heat indicator
Warning! Risk of burns from residual
heat! After you switch the appliance
off, the cooking zones need some time to
cool down. Look at the residual heat
indicator .
Use residual heat for melting and keeping
food warm.
Touch or of the Timer to set the time
00 99
between and
lot light flashes more slowly, the time counts
down. Set the heat settings.
If the heat setting is set and the time set has
elapsed, acoustic signal appears,
es, and cooking zone switches off. If cooking
zone is not in use and the time set has
elapsed acoustic signal appears and
flashes.
Select for a cooking zone to switch off
the function, and the pilot light of the cook-
ing zone selected flashes faster. Touch
and the remaining time counts backwards
00
to . The pilot light goes out.
STOP+GO
The Stop+Go function sets all cooking zones
that operate to the lowest heat setting (
).
When Stop+Go operates, you cannot
change the heat setting.
The Stop+Go function does not stop the tim-
er function.
• To activate this function touch
symbol comes on.
minutes. When the pi-
00
flash-
00
. The
8