Technical Information - IKEA DAGLIG Bedienungsanleitung

ENGLISH
Problem
Acoustic signal sounds,
appliance switches off.
The residual heat indi-
cator is not displaying
anything.
symbol plus a num-
ber appears on the
heat setting display.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.

Technical information

Rating Plate
Made in Germany
© Inter IKEA Systems B.V. 1999
702.228.18
21552
PQM
The graphic above represents the rating
plate of the appliance (without serial num-
ber which is generated dynamically during
the production process), which is located at
its underneath surface of the casing.
Possible cause
One or more sensor fields have
been covered for longer than
10 seconds.
The cooking zone was only on
for a short time and is there-
fore not hot.
Electronics fault.
Uncover sensor field.
If the cooking zone is supposed
to be hot, call the After Sales
Service.
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house's electric system) If
after switching on again,
displayed again, call the cus-
tomer service department.
If you operated the appliance wrongly,
or the installation was not carried out
by a registered engineer, the visit from the
customer service technician or dealer may
not take place free of charge, even during
the warranty period.
Model DAGLIG Typ 58 HAD 56 AO 7,1kW
PNC 949 594 312 01 S NO ............... 220V-240V AC 50-60 Hz
Dear Customer, please apply here aside
the sticker you can find in the dedicate
plastic bag inserted inside the hob packag-
ing. This will allow us to assist you better, by
identifying precisely your hob, in case you
will need in future our assistance. Thank you
for your help!
11
Remedy
is
230 V
DGT