Technical Information - IKEA DAGLIG Bedienungsanleitung

ENGLISH
• Do not use silicon sealant between the
appliance and the worktop. Avoid
installing the appliance next to doors
and under windows as hot cookware
may be knocked off the rings when doors
and windows are opened.
• Only an authorized service engineer can
install, connect or repair this appliance.
Use only original spare parts.
Electrical connection
• Before connecting, check that the
nominal voltage of the appliance stated
on the rating plate, corresponds to the
available supply voltage. Also, check the
power rating of the appliance and
ensure that the wire is suitably sized to
suit the appliance power rating (refer to
the Technical information chapter). The
rating plate is located on the lower
casing of the hob.
• The appliance is not provided with mains
cable. Buy the right one from specialized
dealer. Single-phase or two-phase
connection requires the mains cable of
type H05BB-F/H05V2V2-F Tmax 90°C
(equal or higher).
• The appliance works perfectly on AC
230 V, AC 220 V~ or AC 240 V~ 50 Hz
electrical network.

Technical information

Rating Plate
Made in Germany
© Inter IKEA Systems B.V. 1999
702.228.18
21552
PQM
The graphic above represents the rating
plate of the appliance (without serial
number which is generated dynamically
during the production process), which is
• You must have the means for
disconnection incorporated in the fixed
wiring. Have the appliance connected to
the mains using a device that allows the
appliance to be disconnected from the
mains at all poles with a contact opening
width of at least 3 mm, eg. automatic line
protecting cut-out, earth leakage trips or
fuse.
• You must have the connection and the
connecting links carried out as shown in
the connection diagram (it is located on
the underneath surface of the casing of
the hob). The earth lead is connected to
terminal marked with the symbol and
must be longer than leads carrying
electric current. Tighten the terminal
screws securely! Finally, secure the
connecting cable with the mains cable
cleat and the covering closed by
pressing firmly (lock into place).
Warning! Once connected to the
mains supply check that all
cooking zones are ready for use
by briefly setting each to
maximum power.
Model DAGLIG Typ 58 HAD 56 AO 7,1kW
PNC 949 594 312 02 S NO ............... 220V-240V AC 50-60 Hz
located at its underneath surface of the
casing.
Dear Customer, please apply here aside
the sticker you can find in the dedicate
plastic bag inserted inside the hob
53
230 V
DGT