Installation - IKEA DAGLIG Bedienungsanleitung

ENGLISH
Problem
symbol plus a number
appears on the heat setting
display.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or an After Sales Service.

Installation

General information
Manufacturer is not responsible for any
injury to persons and pets or damage to
property caused by failure to comply
following requirements.
Caution! To proceed with the
installation refer to the assembly
instructions.
Warning! Installation process
must follow the laws, ordinances,
directives and standards
(electrical safety rules and
regulations, proper recycling in
accordance with the regulations,
etc.) in force in the country of use!
Warning! The appliance must be
earthed!
Possible cause
Electronics fault.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
• Loose and inappropriate plug and
• Have the clamping connections correctly
• Use strain relief clamp on cable.
• Follow the connection diagram (it is
Important!
• You must observe the minimum distances
• If there is no oven beneath the hob insert
Disconnect the appliance
from the electrical supply for
a few minutes. Take the fuse
out of the house's electric
system. If after switching on
again,
again, call an After Sales
Service.
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the After
Sales Service technician or
dealer may not take place free
of charge, even during the
warranty period.
Warning! Risk of injury from
electrical current.
voltage.
socket connections can make the
terminal overheat.
installed.
located on the underneath surface of the
casting of the hob).
to other appliances and furniture
cabinets or other units according to
Assembly Instruction.
a dividing panel at a minimum distance
of 20 mm from the bottom of the hob.
52
Remedy
is displayed