Initial Set Up: Rs-485/Rs-422; Driver Installation; Find The Port - Seh Inu-50 Hardwareinstallationshandbuch

 Initial Set Up: RS-485/RS-422
The driver for the INU-50 must be installed on the client.
Afterwards you must find the port for the connected serial
devices.

Driver Installation

Most often, the operating systems automatically searches for
the driver (among the locally available drivers or on the
Internet) and installs it. If installation is not automatic or fails
because the driver cannot be found, you have to install it
manually. To do so, load the proper driver for your client's
operating system:
http://www.ftdichip.com/Drivers/VCP.htm

Find the Port

After the driver has been installed, the client enumerates the
serial interfaces automatically as ports. You must determine
which port is which serial device. To do so, you identify the
new port numbers.
How to proceed depends on the client operating system:
• Windows 18
• Linux 19
17 [en] Hardware Installation Guide