Ryobi RBC30SBSA Bedienungsanleitung Seite 22

EN
FR DE ES IT PT NL
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine will not start.
Engine starts but will not
ac cel er ate.
Engine starts but will only run at
high speed at half choke.
Engine does not reach full speed
and emits ex ces sive smoke.
Engine starts, runs, and
accelerates but will not idle.
Blade continues to rotate
at idle speed.
Line will not advance.
960649002-03.indd 19 960649002-03.indd 19
All manuals and user guides at all-guidesbox.com
SV DA NO FI HU CS RU
English
TROUBLESHOOTING
POSSIBLE CAUSE SOLUTION
No spark. Check spark. Remove spark plug. Reattach the spark
plug cap and lay spark plug on metal cylinder. Pull the
starter rope and watch for spark at spark plug tip. If
there is no spark, repeat test with a new spark plug.
No fuel. Push primer bulb until bulb is full of fuel. If bulb does
not fill, primary fuel delivery sys tem is blocked. Con tact
a servicing dealer. If prim er bulb fills, engine may be
flooded, proceed to next item.
Engine is flooded. Remove spark plug, turn unit so spark plug hole is
aimed at the ground. Rotate the choke dial to "
position and pull starter cord 10 to 15 times. This will
clear excess fuel from en gine. Clean and reinstall spark
plug. Pull starter three times with choke dial at "
en gine does not start, rotate choke dial to "
and repeat normal starting pro ce dure. If engine still fails
to start, repeat pro ce dure with a new spark plug.
Contact a servicing dealer.
Starter rope pulls harder now
than when new.
Engine requires Allow engine to completely warm up. If engine does
approximately three minutes
not accelerate after three minutes, contact a ser vic ing
to warm up. dealer.
Carburetor requires
Contact a ser vic ing dealer.
adjustment.
Use fresh fuel and the correct 2-stroke lubricant mix.
Check lubricant fuel mixture.
Clean air filter. Refer to Clean ing the Air Filter Screen
Air filter is dirty.
earlier in this manual.
Spark arrestor screen is dirty.
Contact a servicing dealer.
Idle speed screw on Turn idle speed screw clockwise to increase idle
carburetor requires adjustment speed. (Fig. 14)
Carburetor requires. Contact a servicing dealer.
adjustment.
1. Line welded to itself. 1. Lubricate with silicone spray.
2. Not enough line on 2. Install more line. Refer to "Line Replacement"
spool. earlier in this manual.
3. Line worn too short. 3. Pull lines while alternately pressing down on
and releasing bump head.
4. Line tangled on spool. 4. Remove line from spool and rewind. Refer to
"Line Replacement" earlier in this manual.
5. Engine speed too slow. 5. Advance line at full throttle.
19
RO PL SL HR ET LT LV SK BG
" position
2011/6/3 2011/6/3
"
". If
3:31 3:31