NEC MultiSync M431-2 Installationsanweisung Seite 8

Do not spill any liquids into the cabinet or use your product near water.
Immediately turn off the power and unplug your product from the wall
outlet, then refer servicing to qualified service personnel. It may cause an
electric shock or start a fire.
DO NOT WET
Do not install the product under equipment that discharges water, such as
air conditioners.
Do not use flammable gas sprays to remove dust when cleaning the
product. Doing so could lead to a fire.
PROHIBITED
Securely fasten the Option Board.
Ensure the Option Board is securely fastened using the original screws
to prevent the Option Board from falling out the product. A falling Option
REQUIRED
Board may expose you to danger.
Usage of the product must not be accompanied by fatal risks or dangers
that, could lead directly to death, personal injury, severe physical damage
or other loss, including nuclear reaction control in nuclear facility, medical
PROHIBITED
life support system, and missile launch control in a weapon system.
Handling the power cord.
The monitor should be installed close to an easily accessible power outlet.
REQUIRED
When connecting the power cord to the product's AC IN terminal, make
sure the connector is fully and firmly inserted.
An incomplete connection of the power cord may cause overheating of
the plug; it allows dust to get on the plug connection, which can lead to a
fire. Touching the pins of a partially inserted plug may lead to an electric
REQUIRED
shock.
Fasten the power cord to the product by attaching the screw and clamp to
prevent loose connection. (Recommended Fasten Force: 120 - 190 N•cm).
Handling the power cord by following below to avoid fire or electric shock.
• When connecting or disconnecting the power cord, pull the power cord
out by holding onto its plug.
• Unplug the power cord from the power outlet before cleaning the
product or when not planning to use the product for an extended time.
REQUIRED
• When the power cord or plug is heat or damaged, unplug the power
cord from the power outlet, and contact a qualified service person.
WARNING
CAUTION
English-6