NEC MultiSync M431-2 Installationsanweisung Seite 5

Do not connect or disconnect the power cord with wet hands.
It may cause an electric shock.
DO NOT
TOUCH
WITH WET
HANDS
Please use the power cord provided with this product in accordance
with the power cord table. Do not exceed the product's specified power
supply voltage where it is installed. Doing so could result in a fire or
electric shock. Please refer to the power supply voltage information in the
specification.
If a power cord is not supplied with this product, please contact us. For all
other cases, please use the power cord with the plug style that matches
REQUIRED
the power socket where the product is located. The compatible power
cord corresponds to the AC voltage of the power outlet and has been
approved by, and complies with, the safety standards in the country of
purchase.
This equipment is designed to be used in the condition of the power cord
connected to the earth. If the power cord is not connected to the earth, it
may cause electric shock. Please make sure the power cord is connected
to the wall outlet directly and earthed properly. Do not use a 2-pin plug
MUST BE
EARTHED
converter adapter.
For proper installation it is strongly recommended to use a trained service
person.
Failure to follow the standard installation procedures could result in
REQUIRED damage to the product or injury to the user or installer.
Please install the product in accordance with the following information.
This product cannot be used or installed without the table top stand or
other mounting accessory for support.
When transporting, moving, or insalling the product, please use as
many people as necessary to be able to lift the product without causing
personal injury or damage to the product.
• We recommend two or more people for the M431-2/M501-2/M551-2
REQUIRED
and four or more people for the M651-2.
• M651-2: DO NOT use this product on the floor with the table top stand.
Please use this product on a table or with a mounting accessory for
support.
WARNING
English-3
EN