Panasonic ER5209 Bedienungsanleitung Seite 3

Charging
1. Set the switch 2. Connect the AC
to "0•charge", adaptor into an
and insert the outlet. The
power cord into charging
the clipper. indicator lamp
will light up.
• The charging time is 8 hours.
• 1 full charge will provide approximately 40 minutes of continuous
operation.
Inserting the attachment
1 2 0/30/40mm, 50/60/70mm comb attachments
1. Adjust the attachment to the desired
trimming height by sliding it until it
clicks while the switch is in "0•charge".
• Set the attachment to the correct position.
Otherwise you cannot set the switch to "1".
• Actual hair length will be a little longer than
the height you set.
ER5209(EU).indb 3
1 3 /6mm, 9/12mm, 15/18mm comb attachments
3mm
3/6mm
15mm
1. Select the
cutting heights
indicated on the
insides and
3. Disconnect the
sides of the
AC adaptor
attachments.
from an outlet
1 N atural cutting attachment
when charging
This attachment allows thinning of hair by cutting
is completed.
from the inner side. Hair volume is reduced, and hair
tips are trimmed at various lengths to leave a natural
look. Desirable hair lengths for this attachment:
30 mm-70 mm (hair lengths shorter than 30 mm may
be too short to cut in some situations.)
1 T hinning Attachment
1. Insert the attachment
over the trimming blades
until it clicks as
illustrated.
6mm
9mm
12mm
9/12mm
18mm
15/18mm
2. Mount the
attachment to
the clipper as
illustrated.
2. To remove the
attachment, push both
sides while pulling the
attachment.
3. To remove the
attachment
from the clipper
3
2007/02/22 18:09:48