Environmental Concerns - IKEA FRAMTID CG7 N Gebrauchsanweisung

ENGLISH

Environmental concerns

Disposal of packing material
- The packing material is 100% recyclable
and is marked with the recycle
symbol ( ). The various parts of the
packing must therefore be disposed of
responsibly and in full compliance with
local authority regulations governing
waste disposal.
Scrapping the product
- This appliance is marked in compliance
with European Directive 2002/96/
EC, Waste Electrical and Electronic
Equipment (WEEE).
- By ensuring this product is disposed of
correctly, you will help prevent potential
negative consequences for the environment
and human health, which could otherwise
be caused by inappropriate waste
handling of this product.
- The symbol
on the accompanying documentation
indicates that it should not be treated
as domestic waste but must be taken
to an appropriate collection centre for
the recycling of electrical and electronic
equipment.
Energy saving
- Only pre-heat the oven if specified in
the cooking table or your recipe.
- Use dark lacquered or enamelled baking
moulds as they absorb heat far better.
- Switch the oven off 10/15 minutes before
the set cooking time. Food requiring
prolonged cooking will continue to cook
even once the oven is switched off.
Declaration of conformity
- This oven, which is intended to come
into contact with foodstuffs, complies
with European Regulation (
n. 1935/2004 and has been designed,
on the product or
)
manufactured and sold in conformity
with the safety requirements of the
"Low Voltage" directive 2006/95/
CE (which replaces 73/23/CEE and
subsequent amendments), the protection
requirements of "EMC" 2004/108/
CE and with the safety requirements
of EEC Directive 2009/142/EC
(ex: EEC 90/396).
Reference to local regulations
France
The installation and maintenance of
the appliance must be carried out by a
qualified skilled technician in accordance
with the regulations in force, and in
particular:
- Decree of 2 August 1977
Technical and Safety Rules applicable to fuel
gas and liquefied hydrocarbon installations
located within residential buildings and
outbuildings.
- Standard DTU P 45 - 204
Gas installations (formerly DTU no. 61-1 -
Gas installations April 1982 + supplement
no. 1 of July 1984).
- Departmental Health Regulations
For appliances connected to the mains
electricity supply.
- Standard NF C 15-100
Low-voltage electrical installations -
Standards.
Belgium
The appliance is supplied with a 1/2"
threaded conical end to be connected to
the gas supply (according to ISO regulations
ISO 7/1 RP 1/2).
The connection must be effected in
accordance with standard NBN D 51-003
using rigid piping or in accordance with
specifications sheet A.R.G.B./03 using
flexible tubing.
The appliance must be installed complete
with an AGB-approved stop valve.
124