Charging Time; Safety Information - Parkside Prmha 20-Li B2 Originalbetriebsanleitung

Warning: The vibration emission
value may differ during actual use
of the power tool from the stated value de-
pending on the manner in which the power
tool is used.
Try to keep the exposure to vibrations as
low as possible. Examples of measures to
reduce vibration exposure are the wearing
of gloves when using the tool and limiting
the working hours. For this purpose all parts
of the operating cycle have to be consid-
ered (for example, times when the electric
tool is switched off and times when it is
switched on but running without any load).
Noise and vibration values were determined
according to the standards and stipulations
mentioned in the declaration of conformity.

Charging time

(min)
PLG 20 A1
PLG 20 A4
PLG 20 C1
PLG 20 A2
PLG 20 A3
PLG 20 C3
PDSLG 20 A1
PDSLG 20 B1
Smart
PLGS 2012 A1

Safety Information

This section describes the basic
safety rules when working with the
machine.
This device may cause seri-
ous injury if used improperly.
To avoid personal injury and
damage to property, read
PAP 20 A1
PAP 20 A2
PAP 20 B1
60 90
45 60
35 45
35 45
35 40
Charging time
The device is part of the (Parkside) X 20 V
TEAM series and can be operated with
batteries of the (Parkside) X 20 V TEAM
series.
Batteries of the (Parkside) X 20 V TEAM
series may only be charged using chargers
of the (Parkside) X 20 V TEAM series.
We recommend that you operate
this appliance with the following bat-
teries only: PAP 20 B1, PAP 20 B3,
Smart PAPS 204 A1, Smart PAPS 208 A1
We recommend charging these
batteries with the following chargers:
PLG 20 A3, PLG 20 A4, PLG 20 C1,
PLG 20 C3, PDSLG 20 A1, PDSLG 20 B1,
Smart PLGS 2012 A1
PAP 20 A3
PAP 20 B3
Smart PAPS 204 A1
120
80
60
60
50
and comply with the follow-
ing safety instructions and
familiarise yourself with all
control elements.
Always stand behind the ma-
chine and hold the handle
with both hands when in use.
GB MT
Smart PAPS 208 A1
240
165
120
120
55
23