Spraytip Selection - Vevor Rp8628 Bedienungsanleitung

·Do not run sprayer dry for more than 30 seconds. Doing so could damage pump
packings
·Protect the internal drive parts of this sprayer from water. Openings in the cover
allow for air cooling of the mechanical parts and electronics inside. If water gets
in these openings, the sprayer could malfunction or be permanently damaged.
·Prevent pump corrosion and damage from freezing. Never leave water or
water-base paint in sprayer when its not in use in cold weather. Freezing fluids
can seriously damage sprayer. Store sprayer with Pump Armor to protect sprayer
during storage.

SPRAYTIP SELECTION

Spray tips are numbered so that:
SPRAYTIP SELECTION
•The first digit, when multiplied by two, gives the spray width in inches (with the spray tip 1
-foot (30cm) away from the surface being sprayed).
•The last two digits specify the orifice size in thousands of an inch (Note: a larger orifice
increases paint flow).
•The following are recommended spray tip orifice sizes for varying types of coating material:
Lacquer & Stain: 0.007" — 0.013"
0.007" 0.009" 0.011" 0.013" 0.015" 0.017" 0.019" 0.021" 0.023" 0.025" 0.027" 0.029" 0.031" 0.033" 0.035"
2-4 107 109
4-6 209
6-8 307 309
8-10 409
10-12 509
12-14 609
14-16
16-18
18-20
CAUTION
Enamel: 0.011" — 0.015" Acrylic: 0.015" — 0.021"
NOZZLE SPRAY TIP SELECTION CHART
Orifice Size (Inches)
111 113 115 117
211 213 215 217
311 313 315 317
411 413 415 417
511 513 515 517
611 613 615 617
711 713 715 717
813 815 817
119 121
219 221 225
319 321 323 325
419 421 423 425
519 521 523 525
619 621 623 625
719 721 723 725
819 821 823 825
923
- 37 -
129
227 229 231
327 329 331 333
427 429 431 433
527 529 531 533
627 629 631 633
727 729 731 733
827 829 831 833
927 931 933
235
335
435
535
635
735
835
935