VEVOR RP8628 Bedienungsanleitung Seite 28

9. Switch Power to On
11. Turn Spray/Prime
Switch to Spray
mode and continue
to spray into waste
bucket
14. If the motor stops, the pump and tubes are primed if it does not stop,
repeat priming steps.
15.Start Painting
Priming
Before painting ensure the Sprayer has been primed(see Priming and
Startup steps) and verify that Nozzle Tip is aligned properly
Note: Remove or cover objects that you want to protect from over spray
and paint mist
10. Paint should work itself from Suction
Tube to Sprayer to Priming Tube until paint
discharges from Return Tube Point gun into
waste bucket and pull trigger
12. Stop spraying
and activate trigger
lock
- 27 -
13. Remove the Priming
Tube from the waste
bucket and clip to
Suction Tube and
submerge in paint pail