Activating Or Resetting A Ps/2 Mouse - G&D FIBREVision-MC4-ARU Installation Und Betrieb

Activating or resetting a PS/2 mouse

NOTE: A PS/2 mouse can only be activated or reset in the setup mode.
Compared to USB mouses, PS/2 mouses do not support hot plug technology. You
can therefore insert the PS/2 plug during operation, but it may be possible that the
computer does not detect the input device.
To enable or reset the PS/2 mouse, the FIBREVision system can be used to send a
special command to the computer.
Since the commands differ depending on the mouse type and the installed operating
system, four different setup keys are provided.
How to activate or reset a PS/2 mouse:
1. Press
Hotkey+Backspace
mode. If the hotkey delay is active, press the key combination for seven
seconds.
2. Press one of the following setup keys to activate or reset the PS/2 mouse:
M  activates the PS/2 mouse of a Linux computer
 activates the PS/2 wheel mouse of a Linux computer
I
E  activates the PS/2 wheel mouse with additional keys of a Linux computer
 resets the PS/2 mouse interface of a Windows computer
R
(default:
Ctrl+Backspace
Configuration
) to activate the setup
G&D FIBREVision · 35