Support Of Dvi Non-Compliant Image Sources - G&D FIBREVision-MC4-ARU Installation Und Betrieb

Enhanced configuration settings
How to change the noise filter level:
1. Press the key combination
activate the setup mode. If the hotkey delay is active, press the key combi-
nation for seven seconds.
2. Press one of the setup keys listed below to activate a noise filter level:
Y  deactivated noise filter level (default))
X  low noise filter level
 high noise filter level
C
1. Use the terminal emulator to establish a connection to the FIBREVision
system.
2. Use the arrow
3. Use the arrow
4. Press Space
Off  deactivated noise filter level (default)
Low  low noise filter level
High  high noise filter level
5. Press Q to leave the Special Extended Options menu.
6. Press to save your settings.
S

Support of DVI non-compliant image sources

NOTE: This function can only be (de)activated in the setup menu.
A resolution higher than 1600 x 1200 pixels causes stripes within the image if, for
example, the screensaver of a Mac mini is displayed.
This affects the way the image is displayed on both the monitor of the computer
module as well as the monitor of the user module.
NOTE:
This factor is caused by weak or disturbed DVI signals of the connected
computer.
The DVI signals of the connected computer that are transmitted to the FIBREVision
system are not DVI compliant.
To improve the image signal of computers that provide a DVI signal which is not
DVI compliant, a special button is implemented in the setup menu. This button is
used to modify the PLL bandwidth.
40 · G&D FIBREVision
Hotkey+Backspace
keys to select the row
keys to select the row
(repeatedly) to activate a noise filter level:
(default:
Special extended options
Video Input Noise Filter
Ctrl+Backspace ) to
and press Enter .
.