Enhanced Configuration Settings; Selecting The Emulation Mode For Input Devices - G&D FIBREVision-MC4-ARU Installation Und Betrieb

Enhanced configuration settings

Enhanced configuration settings
IMPORTANT:
The settings described in this paragraph must only be changed when
requested by the support team.
The enhanced configuration settings in the setup menu enable you to adjust special
features of the FIBREVision system to the specialties of your operating environment:
------ Special extended options ------
--- Check manual,
USB-HID Emulation:
VidIn Noise Filter:
Set PLL bandwidth
Set Defaults for Spec. Options
'Q': quit

Selecting the emulation mode for input devices

NOTE: This function can only be (de)activated in the setup menu.
The computer module either emulates PS/2 or USB input devices that are detected
and used by the connected computer.
If a PS/2 interface (mouse or keyboard) of the computer module is connected to the
computer, the PS/2 emulation is activated independently from a possible connec-
tion to the USB interface.
If, however, only the USB interface is connected to the computer, the USB emulation is
applied. For this purpose, the computer is provided with a USB-HID (Human Interface
Device).
If a special characteristic of your operating environment requires the USB-HID emu-
lation to be permanently deactivated, the emulation of the input devices can be
switched to the PS/2 only
IMPORTANT: In this case, establish a connection between the PS/2 interfaces of
the computer module and the computer.
If -U or -ARU variants are applied, the USB input devices can also be connected via
transparent USB 1.1 interfaces.
38 · G&D FIBREVision
mode.
use with caution --
Auto (default)
Off (default)
Space: Toggle
...
...