Programming/Deleting Transmitters; Delete Transmitter Table In The Receiver; Reset The Receiver To The Factory Setting; Configuration Mode (Only For Authorised Qualified Personnel) - Selve Se Pro 2/20-Rc Betriebsanleitung

commeo initial operation/Setting by radio
Note for settings under point 6.2.: The motor must be selected for this setting with
a transmitter in SELECT mode (Status LED flashes slowly in orange). After completing
the setting, the motor is still selected (see point 6.).

6.2.4. Programming/deleting transmitters

To program or deprogram a transmitter, select the desired channel and push the PROG
button for 1 second. The status LED lights up green to indicate that the transmitter has
been programmed. A red light means that the transmitter has been deprogrammed.
1 s

6.2.5. Delete transmitter table in the receiver

To delete the transmitter table in the receiver, push the PROG button on the transmitter
for 6 seconds. All transmitters programmed in the receiver are deleted. The receiver is
still programmed in the transmitter. The programmed receiver has been cancelled in
the transmitter.
Note: This causes an error message if there are any more programmed
receivers!
If this receiver in operating mode moves over a transmitter which is still
programmed, the transmitter will no longer receive a response and will ack­
6 s
nowledge this with an error message.

6.2.6. Reset the receiver to the factory setting

To reset a receiver to factory settings, push the PROG button on the transmitter for
9 seconds. All settings are reset to factory settings. There are no transmitters and end
positions saved in the motor anymore! The programmed receiver has been cancelled
in the transmitter.
Note: This causes an error message if there are any more programmed
receivers!
If this receiver in operating mode moves over a transmitter which is still
programmed, the transmitter will no longer receive a response and will ack­
9 s
nowledge this with an error message.

6.2.7. CONFIGURATION mode (only for authorised qualified personnel)

In configuration mode, you can set the functions of the radio drives and receivers. The
functions that can be set depend on the type of drive/receiver. You can find more
detailed information on configuration mode in the document 'Configuring radio drives
and receivers', which is available to download at www.selve.de
Status LED transmitter = green  transmitter programmed
Status LED transmitter = red  transmitter deleted
61
EN
EN