Selve SE Pro 2/20-RC Betriebsanleitung Seite 41

Contents
Dear Customer,
by purchasing a SELVE electronic motor you have decided in favour of a quality product
from the SELVE company. This instruction manual describes the installation and ope­
ration of the motor. Make sure to read this handbook before initial operation of the
SELVE motor and adhere to the safety instructions.
After publication of the operating instructions, SELVE shall not be liable for any changes
to norms and standards! Subject to change without prior notice!
1. Safety instructions ............................................................................................. 38
2. Information about the motor features .............................................................. 43
2.1. Designated use ............................................................................................ 43
2.2. Properties .................................................................................................... 43
2.3. SELVE commeo/iveo radio ......................................................................... 44
3. Installation and electrical connection ............................................................. 45
3.1. Installation of the motor into a shaft ......................................................... 45
3.2. Supporting the motors ............................................................................... 46
3.3. Assembly and disassembly of the pluggable cable ................................. 47
3.4. Electric connection ..................................................................................... 47
4. Setting of the end positions ............................................................................. 48
4.1. Delivery status ............................................................................................. 48
4.2. Mechanic requirements ............................................................................. 48
4.3. Setup functions ........................................................................................... 48
4.4. Setting of the end positions with setting switch/switch ......................... 49
4.5. Selection table for settings ........................................................................ 50
4.5.1. Automatic setup-mode, deletion and
automatic setting of the end positions ........................................... 51
4.5.2. Manual setup-mode, deletion and
manual setting of the end positions ................................................ 52
4.5.3. Manual setup-mode, deletion and
manual setting of the end positions ................................................ 53
5. Comfort switching off ........................................................................................ 54
6. commeo initial operation/Setting by radio ...................................................... 55
6.1. Selection of a receiver ................................................................................ 55
6.2. Functions with one selected motor ........................................................... 57
6.2.1. Automatic setup-mode, deletion and
automatic setting of the end positions ........................................... 58
6.2.4. Programming/deleting transmitters ................................................ 61
6.2.5. Delete transmitter table in the receiver .......................................... 61
6.2.6. Reset the receiver to the factory setting ........................................ 61
6.2.7. CONFIGURATION mode
(only for authorised qualified personnel) ......................................... 61
6.3. Transmitter functions .................................................................................. 62
41
EN
EN