Comfort Switching Off - Selve Se Pro 2/20-Rc Betriebsanleitung

EN Comfort switching off

5. Comfort switching off

The relief function at the upper end limit is subsequently disengageable: When comfort
switching off is set, the drive will stop automatically at a point shortly before the upper
end limit. Every 30
th
Therefore the noise development when switching off above will be reduced.
A requirement for the setting of the comfort switching off: both end limit positions must
be set, move against the upper end limit plus relief.
Setting with Setting with
switch setting switch
E
E
1 s
1 s
E
approx. 3 s
approx. 3 s
The comfort switching off can also be executed via radio with a commeo hand­held
transmitter/wall send. This process is described in chapter 6.2.7. CONFIGURATION
mode.
move is a reference move against the upper end limit plus relief.
Drive
Move the drive upwards until it stops automatically
at the upper end limit.
Press the UP button for 1 second.
Press the UP button for approximately 3 seconds
until the drive executes a short confirmation move.
When executing this procedure once again it will
lead to the deactivation of the comfort switching
off.
54