Petsafe easy walk Anpassungsanleitung Seite 3

Fitting the Harness
STEP 1
Fit the Shoulder Strap
1. Open the quick snap buckle on the belly strap.
2. Place the shoulder strap over the dog's head with the chest strap resting on the dog's
chest (1A).
3. Adjust the shoulder strap so that the connector ring sits above and behind the dog's
shoulder (1B).
1A
STEP 2
Fit the Belly Strap
1. Tighten the shoulder strap to a
comfortably snug fit, allowing for just a
finger's width underneath. The snug fit
is required because the girth creates the
"foundation" that keeps the harness in
place (2A).
2. When the girth (shoulder and belly straps
combined) is fitted correctly, it should
resemble a vertical line.
4
1B
2A
petsafe.com
STEP 3
Fit the Chest Strap
1. After you have the girth properly secured, begin to fit the chest strap. Gently press fingers
on lower front of dog's chest to locate the breastbone (3A).
2. Adjust each portion of the chest strap equally to keep the D-ring centered (3B).
3A
3. When adjusted correctly, the chest strap will be horizontal, resting over the dog's
breastbone. It should sit nearly parallel to the ground and should not "hang down" or
gap (3C).
4. Attach the 1.8 nylon lead to the D-ring on the chest strap (3D).
3C
Tip
You may need to remove the harness during fitting to make these adjustments.
Also, dogs may "tense up" during fitting, so check the fit again after the dog has
walked in the harness for a few minutes.
D-Ring
Chest Strap
petsafe.com
3B
Shoulder Strap
Connector Ring
Belly
The Perfect Fit!
Strap
3D
5