Silvercrest SPBT 5 A1 Bedienungs- Und Sicherheitshinweise Seite 10

Sudden temperature changes may
cause condensation inside the
product. In such cases, allow the
product to become acclimatised for
a few hours before using it again!
Do not place burning candles or
naked flames on or near the
product.
Do not use the product near heat
sources or other appliances emit-
ting heat!
Do not expose the record player
or the mains adapter to high
temperatures.
Protect the product from drip water
and splash water. Only use the
product in a dry environment.
Do not place any vases or similar
containers on or near the product.
The container could tip over and
the escaping liquid could cause a
short-circuit. If liquids get into the
product or the mains adapter,
disconnect the product from the
mains power supply immediately.
The product must only be used
once again after it has been
checked by a specialist.
Always hold the mains adapter
by the housing; do not tug at the
cable to unplug it from the socket.
z Initial use
z Choose place of installation
When choosing where to set up your record player,
take the following conditions into account to ensure
that the product works safely and correctly:
Place the product on a firm, flat and horizontal
base.
Do not set up the device in a hot, wet or very
moist environment (e.g. bathroom) or near
flammable materials. Protect the product from
direct sunlight and impacts.
Do not remove the feet from the product. Other-
wise air circulation cannot be guaranteed.
Ensure that the plug socket remains accessible
at all times so that the mains adapter
unplugged quickly if required.
The surfaces of furniture may contain components
that can corrode and soften the product's feet. If
necessary, place a mat under the product's feet.
z Select the mode
Briefly press the MODE button to select play-
back mode.
– the function LED
11
BLUETOOTH is coupling.
®
– the function LED
11
BLUETOOTH is connected.
®
– the function LED
11
player mode/Aux-in mode is activated.
– the function LED
11
USB mode is activated.
z Using the record player
Make sure that all transport, packaging and safety
materials have been removed from the product be-
fore using it for the first time.
Insert the connector for the mains adapter
into the DC input jack
housing, then insert the mains adapter
the mains socket.
can be
26
flashes in blue when
lights up in blue when
lights up in red if record
lights up in green when
26
at the back of the
27
into
26
GB 9