Silvercrest SPBT 5 A1 Bedienungs- Und Sicherheitshinweise Seite 11

Remove the protective cover
and keep it in a safe place for later use.
25
Set the speed switch
(revolutions per minute). Select the speed that
applies to the record that is to be played. The
speed is usually printed on the cover or on the
label of the record. Long-play (LP) records are
generally played at 33 1/3 rpm, so 33 should be
chosen. Singles and maxi singles are usually
played at 45 rpm. Older records / shellac re-
cords are usually played at 78 rpm.
Turn the ON/OFF switch
switch on the record player. The red LED status
indicator switches on. Adjust the volume by
19
further turning the volume control
Place a record on the turntable spindle
record adapter
6
insert it onto the turntable spindle
the single on the turntable
Raise the tonearm
lever , then move the tonearm
8
handle so that the stylus
23
outermost edge of the record or is at the start of
the track that is to be played.
Slowly lower the tonearm
playing when the stylus
with the record.
Adjust the volume if necessary by turning the
volume control
21
The turntable on the record player stops when
4
the end of the record is reached.
Use the tonearm lever
tonearm (the turntable
7
again). Move the tonearm lever
the tonearm lock
20
once again using the tonearm lever
clip on the tonearm lock
into place.
Secure the stylus
25
cover back into position.
24
Switch off the record player at any time by rais-
ing the tonearm
7
then turning the ON/OFF switch
OFF position by moving it anti-clockwise (click).
10 GB
from the stylus
24
to 33, 45 or 78 rpm
9
clockwise and
21
.
21
5
is required for singles. First
, then place
5
.
4
by pulling up the tonearm
7
via the pickup
7
is placed on the
25
. The record starts
7
comes into contact
25
again.
again to raise the
8
starts to spin once
4
back to/into
8
, then lower the tonearm
. Use the
8
to lock the tonearm
20
by putting the protective
with the pickup handle
to the
21
z Connecting headphones
The record player has a stereo headphone connec-
tion so that you can use it without disturbing others.
The speakers do not work if headphones are con-
nected.
Insert the jack (3.5 mm jack plug) on the head-
phones (not included) into the headphone jack
Turn the volume control
z Connecting the product to an
external amplifier
This product can be connected to analogue audio
. The devices and be amplified.
Connect the additional device (not included) to
the AUX IN jack
(not included).
Press the PLAY button on the additional device
and go through the tracks on the additional
device in the usual manner.
Adjust the volume by turning the volume control
or the controls on the additional device that
21
is connected.
Switch the record player off by putting the
ON/OFF switch
z Connecting the product to an
external speaker
When connecting the record player to external
speakers (via a suitable amplifier), use a twin
phono to twin phono cable (not included).
7
Connect the red and white connectors with the
L white
7 28
record player and with the audio input on the
amplifier. Always make sure that the red con-
nectors are inserted into the red jacks and white
connectors are inserted into the white jacks.
,
23
to monitor the volume.
21
with a 3.5mm jack cable
30
into the OFF position (click).
21
and R red line out jacks on the
29
.
22