Silvercrest SNOT 20 A2 Bedienungs- Und Sicherheitshinweise Seite 18

Note: Desired trim length can only be achieved of the
product is held perpendicularly to the skin's surface.
Switch the product on as described in the chapter
"Switch on / off".
Position the product on the area at a right angle and
slowly pull in / against the direction of hair growth.
Repeat this step until satisfied trim is attained.
After using switch the product off as described in the
chapter "Switch on / off".
To trim hair just above the skin surface, remove the
dual comb attachment and guide the blade
8 12
directly over the skin in the desired area.
Note: To trim only individual hairs, adjust the angle
of the blade and guide this against the individual
12
hairs.
Shortening or shaping small beards
and sideburns
Place the beard contouring tool onto the product
9
as described in the chapter "Attaching / removing the
attachment".
Switch the product on as described in the chapter
"Switch on / off".
18 GB