Instructions For Disposal; Behaviour After Replacing Batteries; Teaching-In; Teaching-In Directly To Homematic Devices - HomeMatic HM-RC-8 Bedienungsanleitung

Start-up

Instructions for disposal:

Used batteries should not be disposed of
with regular domestic waste! Instead,
take them to your local battery disposal
point.

5.1.3 Behaviour after replacing batteries

Once the batteries have been inserted, the remote
control performs a self-test/restart (approx. 2 seconds).
The LED flashes red, green and orange briefly (LED
test display). Initialisation is carried out.
If the batteries are too weak for the device to
continue being used, the 5 brief red flashes take
place directly after the button is pressed. In this
case, you have to replace the batteries with two
new ones.

5.2 Teaching-in

Please read this entire section before starting
the teach-in procedure!
To integrate the remote control into your HomeMatic
system and enable it to communicate with other Home-
Matic devices, you must teach it in first. You can teach-
in the remote control directly to other HomeMatic de-
vices or to the HomeMatic Central Control Unit.
38

5.2.1 Teaching-in directly to HomeMatic devices

If you want to teach-in the remote control to one or
more HomeMatic devices, you must put the devices to
be taught-in into teach-in mode and select the required
button/channel.
During teach-in mode, always one left and one
right button are taught-in as button pair. When
pressing a left button to teach-in the function
„Off", the function „On" will be taught-in for the
right button automatically. This also applies to
the other three pairs of buttons.
During teach-in, please make sure you maintain
a distance of at least 50 cm between the devic-
es.
To teach in, proceed as follows:
• You will find the teach-in button (G) on the back side
of the remote control under the cover. Remove the
cover and briefly press the teach-in button with a
pointed object.
Start-up
39