Dmx-Controlled Operation; Focusing - EuroLite LED SL-350 Bedienungsanleitung

OPERATION
After you connected the effect to the mains, the LED SL-350 DMX Search Light starts running. The power
switch is on the right side of the panel.
During the reset of 30 seconds, the motors are trimmed and the device is ready for use afterwards.
Via the Lamp ON/OFF switch you can turn the LED on and off.
The strobe fader controls three different strobe effects: Up to 50% of the fader path controls strobe speed,
from 50% to 75% of the fader is pulse effect and from 75% to 100% is random mode.
Half-tones can be created by pressing the desired adjoining color buttons simultaneously.
Please note: white and red can not produce a half-tone.

Focusing

Step 1: Loosen the focus button on the side of the device.
Step 2: Adjust the focus by sliding the lens housing forward or backward.
Step 3: Tighten the focus button.
Control Board
The Control Board offers several features: you can easily set the starting address or execute a reset.
MODE UP DOWN ENTER
Mode
A001
REST

DMX-CONTROLLED OPERATION

You can control the devices individually via your DMX-controller.
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Press the MODE button until the display shows A001. You can now set the desired address via the UP or
DOWN buttons. Press ENTER to confirm.
Press the MODE button in order to return to the main menu.
Please, be sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain.
If several devices are addressed similarly, they will work synchronically.
Enter the menu by pressing the MODE-button. Browse through the menu by
pressing UP or DOWN. Press ENTER in order to select the desired menu. You
can change the selection by pressing UP or DOWN. Press ENTER in order to
confirm. You can leave every mode by pressing MODE. The functions provided
are described in the following sections.
Setting Function
001 - 511 Set starting address
ON / OFF Execute reset
20/24 00102135.DOCX, Version 1.0