Technical Data - Mpm Mod-22 Bedienungsanleitung

3. Pull and remove the water filter body. It can be washed with warm and soapy water or under tap
water. Let filter dry before replacing it.
4. Filter (A8) and (B3) can be washed in warm water with some soap or in running water. It should be
dried properly before it is put on float chamber again.
ATTETION! Filters must not be cleaned in hot water or washed in a washing machine.
5. Check if a valve in float chamber can be moved easily. If necessary, clean it. In order to check if the
float works properly lift the engine's set and shake it.
6. The cleanness of HEPA 13 filter should be checked periodically. It should be replaced after a cer-
tain time of usage when it looses its qualities.
7. You can dock the assembled suction tube and accessories on the hoover by placing the docking
clip (H8) in the docking slot (A9). You can place the slot attachment at the other end of the clip (H8).

TECHNICAL DATA

The technical parameters are given on the data plate
of the product
Maximum noise level: L
Power cord lenght: 6 m
NOTE! MPM agd S.A. reserves its right to modify the technical data.
Proper disposal of the product (waste electrical and electronic equipment)
Marking on the product indicates that after the service-life of the product expires, it should not be dis-
posed with other type of municipal waste. Used equipment may have a negative impact on the environ-
ment and health of people due to potentially containing hazardous substances, mixtures and components.
Mixing electric waste with other types of waste or disassembling those in an unprofessional manner may
cause a release of substances that are hazardous to the environment and health. Used equipment should
be handed-over to a point for collection of electric waste. In order to obtain detailed information regarding the
electric waste collection points, the user should contact the municipal point of electric waste collection or used
equipment processing department.
= 81 dB
WA
EN
35