MPM MOD-22 Bedienungsanleitung Seite 31

EN
A5 – HEPA filter
A6 – Cover of HEPA filter case
A7 – Float chamber
A8 – Foam filter
A9 – Docking station socket
A10 – Carrying handle
B. Container. The container section is a middle part of a vacuum cleaner, used as a con-
tainer to collect dust and dirty water. This section is attached to engine's set with clamps.
A container for a shampoo and clean water (washing liquid) is located under the water
filter container.
B1 – Container
B2 – Water filter element
B3 – Water filter sponge
B4 – Water filter tube
B5 – Rubber gasket
B6 – Clamps
B7 – Locks sockets
B8 – Sucking inlet
B9 – Rubber caps for the water filter head
C. Washing liquid container. Washing liquid container has a shampoo and clean water.
When the pump works, shampoo and water are taken from the tank. Liquid going from
the container through a hose is sprayed. Liquid container is situated between a water filter
container and a base with wheels.
C1 – Washing liquid container
C2 – Short washing hose
C3 – Short washing hose connector
C4 – Indicator of water level
D. A base with wheels.
D1 – Base
D2 – Wheels
D3 – Lock
E. Hose. This section includes a sucking hose with a handle and sucking tubes. Sucking
attachments connected with container's set through putting the hose into sucking inlet.
Sucking tubes are jointed with each other and then connected to a handle. The handle
has washing liquid feeder and sucking power regulation. The hose can be put on engine's
set with the use of hanger.
E1 – Element fixing a sucking hose
E2 – Element fixing a washing hose
E3 – Washing liquid hose
E4 – Lock the pipe
E5 – Sucking hose
E6 – Liquid feeder lever
E7 – Sucking power regulation
E8 – Handle
31