Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Disclaimer
Before operating your Desktop CNC Machine, please read the manual.
or damage to the CNC Machine.
this
manual.
SainSmart
cannot control the conditions
We do not assume responsibility
connected with the assembly,
The information
in this manual is provided without any warranty, expressed
Please be careful
dangerous
• Genmitsu CNC Machines are for Indoor Use Only.
• You must be 18 years or older to operate this machine, unless supervised
• Wear the proper Personal Protection
• Always place the CNC Machine on a stable surface.
• The SainSmart
Genmitsu CNC Machine is supplied with Switchable
power supply; it may cause malfunctions
• Ensure the Emergency
• Never disassemble
• DO NOT TOUCH the machine spindle, or place any body part near the working area when the machine is operating.
Injury may occur.
• DO NOT leave children unsupervised
• DO NOT leave the machine unattended
• Ensure your CNC Machine is in a well-ventilated
02
Anyone who operates the Desktop CNC machine should know and understand
in which you assemble your Genmitsu CNC machine or verify if it was done properly.
and expressly disclaim liability for loss, injuries, damage, or expense arising out of, or in any way
handling, storage, use, or disposal of the product.
when using your CNC machine.
areas.
Equipment
or damage to the machine.
stop button is easily accessible
the Power Supply or Electrical Components.
with the CNC Machine even when it's not operating.
while it's operating.
Failure to do so may lead to personal injury, poor results,
or implied, regarding its correctness.
This machine
by a knowledgeable
(Safety Glasses etc.).
Power Supply 230 VAC or 1 IOVAC. Never use a different
at all times.
This will VOID the warranty.
area. Some Materials may discharge smoke or fumes during operation.
is an electrical
device with moving
adult familiar with the machine.
Injury may occur.
the contents of
parts and
Serious
Werbung
