Genmitsu 3018-PROVer Benutzerhandbuch Seite 34

3.5 Connecting
What you will need
(Stepper Motor Cables are cables with white plugs on both ends)
32
the Stepper Motor cables
Stepper Motor Cable, X-Axis, 17cm
Stepper Motor Cable, Y-Axis, 52cm
Stepper Motor Cable, Z-Axis, 28cm
Step 1: Locate all three stepper motors. X-Axis
stepper motor is on the side of the machine. Y-Axis
stepper motor is on the bottom of the machine in the
back. Z-Axis stepper motor is on top of the machine.
As shown in the photos below.