Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Final
Checks
Lubricate the Threaded
Dry' PTFE based lubricant or similar (Not included) to help stop any
Lubricate
dust sticking to the rods
the
axes
Note: Part of the normal maintenance
threaded
The bed and anything which will be mounted on it will be able to move fully from front to back without
Check
snagging on any cables.
Cable
The cables connecting
routing
Z and
X axes.
Access to the Motherboard
Emergency
This is a normally closed switch. Make sure before powering on the Emergency
stop button
by turning the button in the direction of the arrows and letting it spring out.
This controls the current going to the stepper motors. This has been pre-set for the PROVer and no
Vref
adjustment
rods on all the axes, It is suggested
rods
and
re-lubricate
as needed.
the Z Axis and spindle motor will move freely and not restrict the movement of the
24V power supply and the USB Cable connection
is necessary
or advised.
to use a
is to periodically
clean the
are not obstructed.
Stop button is released
37
Werbung
