Security Advices; Utilized Symbols; Possible Threats; Further Information On Workplace Safety - Senco SHLCN90 Betriebsanleitung

SECURITY ADVICES

2 Security Advices

2.1 Utilized symbols

Danger
Non-compliance with this warning will result in death or serious injury.
Warning
Non-compliance with this warning will result in slight injuries or heavy material damage.
Caution
Non-compliance with this warning can result in light material damage.
Info
Important information
Ear protection
Wear ear protection.
Eye protection
Wear eye protection.

2.2 Possible threats

When operating the SHLCN90 these are potential risks caused by
•Free-flying slide on fasteners and / or work splitting
•High noise

2.3 Further information on workplace safety

Ear protection
When working with the SHLCN90 wear ear protection.
Eye protection
When working with the SHLCN90 wear eye protection.
•Only use a completely assembled and intact tool and do not change or modify the tools.
•Immediately disconnect defective or faulty tools from the compressed air supply and hand over the tool for inspection by
authorized personnel.
•Unplug the unit during all maintenance and adjustments from the air supply.
•Make sure the maximum operating pressure is not exceeded.
•Never reach into the operational system.
•Avoid weakening and damage to the device, such as by
- Hammering or engraving
- Unauthorized modification measures
- Cause the device to templates of hard material (e.g. steel)
Any other form of violence
-
•Repair work may only be carried out by personnel authorized by the manufacturer or other competent professionals
using original Senco spare parts.

2.4 Noise

Noise measurement acc. EN 292, Part 2, methods of measurement according to DIN IEC804 Noise: LpAeq = 97,5 dB (A).
The noise characteristic value is system-related and may vary during use. This depends on the environment, the work
piece, the number of driving down processes u.A.
GB
5 5